1.1 This consumer safety specification establishes performance requirements, test methods, and labeling requirements to promote the safe use of infant bath tubs. It also covers slings, pads, inserts and similar accessories when such accessories are used with the infant bath tub.

1.2 This consumer safety specification is intended to reduce the risk of death and minimize injury to infants resulting from use and reasonably foreseeable abuse of infant bath tubs and infant bath tub accessories.

1.3 No infant bath tub or infant bath tub accessory produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein.

1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5 The following precautionary caveat pertains only to the test methods portion, Section 7, of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Test Requirement 测试要求：

5 General Requirements
5.1 Sharp Points and Edges(16 CFR 1500.48&49)
5.2 Small parts
5.3 Surface Coating(16 CFR 1303)
5.4 Resisance to collapse
5.5 Scissoring,Shearing,Pinching
5.6 Openings
5.7 Protective Components
5.8 Toys accessories(ASTM F 963)
5.9 Labeling
6 Performance Requirements
6.1 Restraint system
6.2 Static load
6.3 Specific requirement for suction cups
8 Marking and Labeling
9 Instructional Literature

Sample Size 样品数量 / 送样规格: 3 sets of completed products with assembly instruction and all accessories (if applicable) is recommended. 1 more set required for toxicity test.
Lead Time / TAT (Turn Around Time) 测试周期: 常规服务 Regular service 9-12 working days

Report Summary 报告摘要: