| 标准编号 Standard/Code | 标准名称 Standard Title |
| EN 13034 | Protective clothing against liquid chemicals - Performance requirements for chemical protective clothing offering limited protective performance against liquid chemicals (Type 6 and Type PB [6] equipment) |
This document specifies the minimum requirements for limited use and re-useable limited performance chemical protective clothing. Limited performance chemical protective clothing is intended for use in cases of a potential exposure to a light spray, liquid aerosols or low pressure, low volume splashes, against which a complete liquid permeation barrier (at the molecular level) is not required. This document covers both chemical protective suits (Type 6) and partial body protection (Type PB [6]). Chemical protective suits (Type 6) cover and protect at least the trunk and the limbs, e.g. one-piece coveralls or two piece suits, with or without hood, boot-socks or boot-covers. This document specifies minimum requirements for the connections between different parts of Type 6 suits by the use of a reduced whole suit spray test using a variant of EN 468, as described in 5.2. Partial body protection of similar limited performance (Type PB [6]) covers and protects only specific parts of the body, e.g. coats, aprons, sleeves etc. They should not be tested to the whole suit test (5.2).
Test Requirement 测试要求：
Products must comply with EN 340
This standard sets out the general requirements for protective clothing i.e. materials shall not be known to cause skin irritation or have any adverse effect to health. This also details garment sizing, labelling etc.
Test Requirements for Materials (fabric)
Materials for Type 6 clothing are tested for the following properties; EN14325: 2004 details the test methods & performance classification of chemical protection clothing materials, seams, joins and assemblages.
Clause in EN 14325 Performance requirement
4.4 EN 530 Abrasion
4.7 EN ISO 9073-4 Trapezoidal tear resistance
4.9 EN ISO 13934-1 Tensile Strength
4.10 EN 863 Puncture Resistance
4.11 EN 374-3 or EN ISO 6529 Resistance to permeation by chemicals (replaced EN369)
4.12 EN 368 Repellency to liquids
4.13 EN 368 Resistance to penetration by liquids
4.14 EN 13274-4 Resistance to ignition (replaced ISO 6941)
Sample Size 样品数量 / 送样规格: on request
Lead Time / TAT (Turn Around Time) 测试周期: 常规服务 Regular service 7-9 working days
Report Summary 报告摘要:
