5.1 Fabrics intended for this end-use should meet all of the requirements listed inTable 1 .

5.2 It should be recognized that fabrics can be produced with an almost infinite number of combination of construction variables (for example, type of fibers, percentage of fibers, yarn twist, yarn number, warp and pick count, chemical and mechanical finishes). Additionally, fashion or aesthetics dictate that the ultimate consumer may find acceptable articles made from fabrics that do not conform to all of the requirements in Table 1.

5.2.1 Hence, no single performance specification can possibly apply to all the various fabrics that could be utilized for this end-use.

5.3 The uses and significance of particular properties and test methods are discussed in the appropriate sections of the specified test methods.

1. Scope

1.1 This performance specification covers woven fabrics comprised of any textile fiber or mixture of fibers to be used in slipcovers.

1.2 These requirements apply to both the length and width directions for those properties where fabric direction is pertinent.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Test Requirement 测试要求：

Breaking  stringing/ 拉伸强力
Tear Strength/ 撕破强力
Yarn slippage/ 纱线滑移
Yarn distortion/ 织物纱线变形
Dimensional Change/尺寸变化
Fabric  Appearance /织物外观
Colorfastness to /色牢度
Laundering/水洗
Dry cleaning/干洗
Burnt gas fumes/烟熏
Perspiration/汗泽
Light(20AFU)/ 光照（20褪色单位）
Ozone/臭氧
Flammability /燃烧性能

Sample Size 样品数量 / 送样规格: on request
Lead Time / TAT (Turn Around Time) 测试周期: 常规服务 Regular service 7-9 working days

Report Summary 报告摘要: