This European Standard specifies requirements for single-axis hinges, of lift-off or fixed pin type, for use on access windows and doors. Such windows and doors may or may not be fitted also with door closing devices. It includes tests for static loads, shear strength and allowable wear during durability cycling for the following hinges: a)mounted on the edge of the door leaf or window sash and opening in one direction only; b)whose axis of rotation is within 30 mm of an edge of the movable element for a door leaf mass of up to 160 kg; c)whose axis of rotation is within 30 mm of the edge for a window sash with a mass up to 60 kg. This European Standard classifies hinges for four categories of use (see annex A) and also specifies the maximum permissible torque arising from frictional resistance generated within the hinge during endurance testing. Corrosion protection requirements are specified for those hinges which are not intended to be protected after fitting. There are no restrictions on the materials or the methods of fabrication used providing the hinge conforms to the requirements relevant to its application. The suitability of single axis hinges for use on fire/smoke compartmentation door assemblies is determined by performance tests conducted in addition to the performance tests required by this European Standard. Annex B indicates additional requirements for these products. This European Standard does not apply to hinges incorporating spring-assisted door-closing mechanisms. Door closers incorporating door co-ordinator devices (with or without electrically powered hold-open devices) are covered by EN 1158. Although the fastenings used to fix hinges to window assemblies and door assemblies are not covered by this European Standard, if the type of fastening to be used is supplied or specified by the manufacturer, such fastenings are used for the tests. NOTE Performance standards for complete windows and door assemblies (in the course of preparation byCEN/

Test Requirement 测试要求：

5.1 Initial friction torque measurements 初始摩擦扭矩测量
5.2.1 Load-Deformation Test 静载变形测试
5.2.2 Overload Test 过载测试
5.3 Shear Strength Test 剪切强度测试
5.4 Durability Test 疲劳测试                                 
5.5 Corrosion Resistance Test 腐蚀抗性测试
5.6 Hinges for use on fire-resistance and/or smoke-control doors 用于防火或烟控门上的铰链附加测试
5.7 Hinges for use on burglar-resistance doors 用于防盗门上的铰链附加测试
8 Marking 标签

Sample Size 样品数量 / 送样规格: 12pcs
Lead Time / TAT (Turn Around Time) 测试周期: 常规服务 Regular service 7-24 working days

Report Summary 报告摘要: