This Standard establishes performance requirements for Series 1000 and Narrow Stile Mortise Locks and Latches and includes operational, cycle, strength, material evaluation, security and dimensional criteria. Tests to evaluate decorative and protective finishes for these products are described in ANSI/BHMA A156.18 for Materials and Finishes, and are required to complete certification. Tests described in this Standard are performed under laboratory conditions. In actual usage, results may vary because of installation, maintenance, and environmental conditions.

Test Requirement 测试要求：

9.1 Dead bolt torque
9.2 Force or torque retract latch bolt or latch bolt and dead bolt
9.3 Force to latch door
9.4 Torque to retract  latch bolt by key
9.5 Minimum projection of  latch bolt when depressed to dead latched position
9.6 Minimum projection of auxiliary dead latch to deadlock latch bolt
9.7 Warped door test
9.8 bolt strength test
9.9 Axial load test
9.10 Vertical load test
9.11 Locked outside lever torque test
9.12 Unlocked  lever  torque test
9.13 Unlocked entry handleset load test
10.1 Knob, lever or paddle impact test
10.2 Cylinder guard or escutcheon impact test
10.3 Cylinder guard or escutcheon tension test
10.4 Cylinder body or housing tension test
10.5 Locked knob, lever or paddle test
10.6 Cylinder body or housing torque test
10.7 Cylinder guard or escutcheon torque test
10.8 Cylinder face impact test
10.9 Dead bolt or latch bolt or dead bolt and latch bolt impact test
10.10 Bolt pressure test
10.11 Dead bolt sawing test
11 Cycle tests
12.2 Salt spray test
12.3 Humidity test
12.4 Finish hardness test
12.5 Taber test
12.6 Prespiration test
12.7 Ultra violet light and condensation test
13.1 Knob crush test
13.2 Rose and escutcheon dent test
13.3 Outside rose deformation test

Sample Size 样品数量 / 送样规格: 10pcs
Lead Time / TAT (Turn Around Time) 测试周期: 常规服务 Regular service 12 working days

Report Summary 报告摘要: