This specification establishes parameters for the design and manufacture of fitness equipment intended for use by individuals age 12 and above. The design and construction requirements for the following are specified: (1) stability, (2) support, (3) edges, corners, and tube ends, and (4) moving parts in accessible areas such as rotating and reciprocating points. The equipment shall meet the guarding, enclosure, and spacing requirements specified for: (1) squeeze, shear, and crush points, (2) adjustment and locking means, (3) handgrips (integral, applied, and rotating) and foot support, (4) load development and transmitting components such as ropes, belts, chains, and other means, and chain or gear drives, and (5) intrinsic, extrinsic, and endurance loading. The documentation shall include the following: assembly instructions, list of equipment parts, operational instructions, and maintenance instructions. Adequate warnings or warning labels alerting users, third parties, and service personnel to hazards associated with use and service of the equipment shall be provided for consumer, commercial, and institutional fitness equipment. The requirements for site-specific labels and user weight restrictions are specified.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This specification establishes parameters for the design and manufacture of fitness equipment as defined in 3.1.9.

1.2 It is intended that these fitness products be used in an indoor setting or environment.

1.3 It is the intent of this specification to specify products for use by individuals age 13 and above.

1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Test Item 测试名称: ASTM F2276 Specification for Fitness Equipment 踏步机/爬楼机

Test Requirements 测试要求：

4 Design and Construction Requirements
5.1 Squeeze, Shear, and Crush Points
5.2 Adjustment and Locking Means
5.3 Handgrips/Foot Support
5.4 Load Development and Transmitting Components
5.5 Loading
6 Documentation

Sample Size 样品数量 / 送样规格: 3 sets / 3套
Lead Time / TAT (Turn Around Time) 测试周期: 常规服务 Regular service 9 working days

Report Summary 报告摘要: