This standard establishes requirements for Cabinet Locks used on doors, drawers and furniture. Cycle tests, operational tests, strength tests and finish tests are included.Tests described in this Standard are performed under laboratory conditions. In actual usage, results vary because of the material used in the installation, maintenance and environmental conditions.The intent of this standard is to provide fair, uniform and repeatable testing of cabinet locks.

Test Requirement 测试要求：

American national standard for Cabinet locks 橱柜锁

7.1 Operational test 操作测试
7.2 Strength Test 强度测试
(Cylinder plug pulling; Axial load; Bolt strength; Dead bolt end pressure test)
7.3 Cycle test 疲劳测试
Grade 1: 40000 cycles 级别1
Grade 2: 20000 cycles 级别2
Grade 3: 10000 cycles 级别3
4.4.4 over-opening test 铰链过开性能测试
grade 1: NA grade 1 不做
4.16 Finish test
4.16.5.1 Salt spray test
4.16.5.2 Humidity
7.4 Performance after cycle test 疲劳测试后的性能
8 Finish test 镀层测试
 (Salt spray test; Humidity test; Pencil hardness test)

Sample Size 样品数量 / 送样规格: 24 PCS
Lead Time / TAT (Turn Around Time) 测试周期: 常规服务 Regular service 15 working days

Report Summary 报告摘要: