| 标准编号 Standard/Code | 标准名称 Standard Title |
| ISO 2493-1 | Paper and board - Determination of bending resistance - Part 1: Constant rate of deflection |
ISO 2493-1:2010 specifies procedures, based on the two-point loading principle, for determining the bending resistance of paper and board.
ISO 2493-1:2010 applies to the measurement of the bending resistance within the range 20 mN to 10 000 mN. It is not applicable to corrugated board but can be applicable to the components of such board.
The bending angle is 15 and the bending length is 50 mm.
For samples having a bending resistance that is too low to measure with a bending length of 50 mm, a shorter bending length, i.e. 10 mm, can be used.
For boards that tend to be permanently deformed if bent through 15, the half bending angle, i.e. 7,5, can be used.
Test Requirement 测试要求：
挺度
Sample Size 样品数量 / 送样规格: on request
Lead Time / TAT (Turn Around Time) 测试周期: 常规服务 Regular service 7-9 working days
Report Summary 报告摘要:
检测实验室 | TESTING LAB：
安瑞检测认证(广东)有限公司 (CNAS认可实验室)
联系人：陈小姐
电话：13420014231 （微信同号）
邮箱：orange.chen@annraytest.com
网址：www.annraytesting.com
