标准编号 Standard/Code | 标准名称 Standard Title |
ASTM D903 | Standard Test Method for Peel or Stripping Strength of Adhesive Bonds |
This test method details the standard procedures for the determination of the comparative peel or stripping strength characteristics of adhesive bonds when tested on standard-sized specimens and under defined conditions of pretreatment, temperature, and testing machine speed. This method requires the use of a power-driven testing machine with a constant rate-of-jaw separation or of the inclination balance or pendulum type, and conditioning room or desiccator.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope
1.1 This test method covers the determination of the comparative peel or stripping characteristics of adhesive bonds when tested on standard-sized specimens and under defined conditions of pretreatment, temperature, and testing machine speed.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Test Item 测试名称: ASTM D903 180°剥离强度(挠性材料对刚性材料)180°Peeling Strength
Test Requirement 测试要求:
剥离强度
Sample Size 样品数量 / 送样规格: 见下面
胶黏剂适量 - 刚性被粘试片宽度25mm,长度不少于203.8mm,不少于10psc,挠性被粘试片宽度25mm,长度不少于304.8mm,不少于10pcs.
胶黏剂适量 - 刚性被粘试片宽度25mm,长度不少于200mm,不少于5psc,挠性被粘试片宽度25mm,长度不少于300mm,不少于5pcs
Lead Time / TAT (Turn Around Time) 测试周期: 常规服务 Regular service 10 working days
Report Summary 报告摘要: